M.T.H. H9 2-8-0Steam Locomotive Manuel de l'opérateur télécharger pdf (Page 6)

Set Up Checklist

- Lubricate the locomotive

- Prime the smoke unit

- Check to see whether the battery needs to be charged for full sound effects

- Apply power to run as described in the Basic Operating Section of this manual

Lubrication

You should lubricate the engine to prevent it from squeaking. Use

light household oil and follow the lubrication points marked “L” in

Fig. 4. Do not over-oil. Use only a drop or two on each pivot point.

Priming the Smoke Unit

When preparing to run this engine, add

15-20 drops of smoke fluid through the

smokestack. We recommend M.T.H.

ProtoSmoke, Seuthe, LGB, or LVTS fluids.

Do not overfill the unit or the fluid may

leak out and coat the interior engine

components.

H9 2-8-0 Steam Locomotive

DO NOT

OVER OIL

DO NOT

OVER OIL

DO NOT

OVER OIL

Figure 4. Lubrication Points on the Locomotive

Running the engine without a primed

smoke unit may cause damage

Figure 5. Smoke Unit Switch Location

If you choose not to add the fluid (or have

already added the fluid but choose to run

smoke-free), turn off the smoke unit

switch located under the water hatch on

the tender (see Fig. 5). Failure either to

add fluid to the unit or to turn it off may

damage the smoke unit heating element

and/or wicking material.

Lubricate Linkage (L)

Lubricate Wheel Axels (L)

Smoke Switch

1 2 3 4 5 6 7 8 9 10 11 ... 30 31

Pas de commentaire

M.T.H. H9 2-8-0Steam Locomotive Manuel de l'opérateur Page 6