M.T.H. Premier Genesis Diesel Locomotive Manuel de l'opérateur télécharger pdf (Page 41)

One of my lights is out.

None of my lights are on.

Most likely you had been running the engine

in DCC or DCS mode and toggled that light

off. Put it back into one of those modes and

turn that light back on. The engine will

remember that when you run it again in

Conventional DC.

Could be the same reason as “One of my

lights is out”

Is the engine getting power? Check to see if

there if voltage on the track or move the

engine a few feet in either direction.

Lights Solution

Motion Solution

When I apply power to the track my

engine starts up (lights and sound) but it

won't move

My engine hesitates at slow speeds.

Lower the track voltage then raise it again.

The engine should start moving. If you apply

greater than 9VDC quickly the engine will just

sit there. Lowering it below 9VDC then raising

it will get the engine moving.

An engine may do this right out of the box if it

has not been lubricated. Follow the lubrication

instructions. Now go ahead and run it.

New engines even after they are lubricated

may take a little bit to get everything run in. Be

a little patient and let it run for a bit. It should

clear up shortly after lubricating and running.

Premier Diesel Engine w/Proto-Sound® 3.0

Genesis

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48 49

Pas de commentaire

M.T.H. Premier Genesis Diesel Locomotive Manuel de l'opérateur Page 41