M.T.H. Premier Genesis Diesel Locomotive Manuel de l'opérateur télécharger pdf (Page 43)

DCC

When I apply power to the track my

engine doesn’t do anything. No lights, no

sound.

Did you press F3 yet? F3 on your DCC

handheld will start your engine up.

Check to see if that section of track has

power. Use a voltmeter or a lit passenger car,

not your tongue.

Slide the engine a couple of feet in either

direction, you may have a bad track section.

Have you got that section electrically isolated

with a toggle switch or other device?

Start-up Solution

Sound Solution

I have no sound on my engine, but my

lights are on and it moves just fine.

When I run Doppler I can hear the

Doppler shift but then the engine sounds

fade out and I can’t get them back.

There's a crackling sound from my

engine

You may have it turned off. Repeatedly press

F6 to cycle through the volume levels (there

are 9 levels, 0-max).

This is normal. You will need to press the F21

button again to turn Doppler off. Your engine

sounds will now return to normal.

Check to see if a screw or some other

material hasn't lodged itself in the underside

of the engine.

Smoke Solution

My engine isn’t smoking at all.

My engine barely smokes.

Make sure you’ve got the smoke switch ON. It

must be ON for the smoke to operate in DCC

Mode.

Press F12 on your DCC handheld. This will

activate the smoke.

If you just filled it with the smoke fluid

sometimes the fluid can make a seal in the

stack blow down the stack to clear the air

bubble.

You may have set the smoke to Low. F13 will

vary the smoke levels. Or, if you were running

it in DCS mode you may have toggled it there

(if you don’t have F13 on your DCC handheld

you will have to put it back into DCS mode

and change it from there), or follow the

instructions starting on pg. 26 to move the

smoke volume into an F Function that exists

on your controller

Check for an obstruction in the smoke

stack

Add 10-12 drops of smoke fluid

Premier Diesel Engine w/Proto-Sound® 3.0

42

Genesis

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 49

Commentaires sur ces manuels

Pas de commentaire